The SDR software shows "no sensor" instead of a value. What is the reason?

This message is shown if no sensor is on top of a channel, or if the signal of this sensor is too weak. If you use 6-well plates or less than 24 SensorVials, the channels without sensor will show "no sensor". If a 24-well SensorDish® is placed on the SDR, and this message is shown, please check if the plate is placed correctly and rests in the groove on the top side of the SDR (see also the SensorDish® Instruction Manual).


Select by industry

Presens TV

Watch tutorials, webinars and informative videos about PreSens optical sensor systems.

All videos